.png){kind=small}
TALOS C750
Anti-terrorism retractable oil-hydraulic bollard
​
GENERAL DESCRIPTION
High-Security Fully Retractable Hydraulic Bollard
Security bollard featuring a retractable post that lowers completely flush with the roadway surface and an integrated hydraulic motor-pump unit.
Designed for heavy-duty, high-security applications and certified to:
-
ASTM F2656-15 M50/P1 (C750 equivalent)
-
PAS 68:2013 V/16,535 lb (N3)/50 mph
-
IWA 14-1:2013 V/15,870 lb [N3C]/50 mph
Engineered to stop a 16,500 lb vehicle traveling at 50 mph, capable of absorbing a minimum of 1,380,000 ft-lbs (1,872,000 J) of impact energy in compliance with the above standards.
Designed for the protection of high-risk and sensitive facilities including military bases, airports, embassies, consulates, financial institutions, correctional facilities, and other sites requiring maximum perimeter security.
​
Construction & Structural Design
The bollard features a rising post extending 43" above finished grade, with a 13-3/4" outside diameter and 1-3/16" wall thickness.
When fully raised, the post is embedded approximately 20" below grade within the foundation enclosure and reinforced by two internal steel reinforcement plates, each 1-3/16" thick, providing additional structural strength.
The rising post is constructed from S355K2H high-strength structural steel, treated with a cathodic electrocoating (e-coat) primer and finished with a polyester powder coat.
For high visibility in all weather conditions, the post is equipped with an approved high-intensity retroreflective band.
The top cap includes a protective rubber edge to reduce injury risk in the event of accidental pedestrian contact.
​
Foundation & Internal Structure
-
Hot-dip galvanized steel in-ground foundation casing
-
Cold-dip galvanized internal structural assembly
This system is specifically engineered for sites requiring the highest level of hostile vehicle mitigation (HVM) and perimeter protection while maintaining full operational capability after impact.
Post diameter (inches) 10.83
​​
Post tickness (inches) 0.79
​
Post height (inches) 39.37
​​
Post finish: polyester powder coating RAL 7016 anthracite grey
​
Piston diameter (inches) 1.38
​
Shaft diameter (inches) 0.98
​
Actual shaft travel (inches) 43.89
​
Frequency of use: intensive 2,000 cycles/day
​
Post material: S355K2H Steel
​
Impact resistance (J) 700,000
​
Crash resistance (J) 2,000,000
​
Maximum static load (lbs) 44
​
Environment working temperature: -4 / 176 ​
​
Rising speed 22 (~5,0s)
​
Lowering speed 22 (~4,9s)
​
Lowering speed rapid descent system
